Page 1 of 1

60s ratios

Posted: Sun May 01, 2005 7:08 pm
by LUXon37s
Hi all

Im thinking of buying a diesel 60 later on this year and im just wanting to know what diff ratios are
avaliable as i have a set of 36in swampers to go on it or would it turn then ok and not need the ratios ?

Any help would be greatfull


GAVIN

Posted: Sun May 01, 2005 7:22 pm
by Shadow
36's would need ratios man, my hj60 drives the 33's alright on standard ratio but youd definantly need a lower ratio to turn 36's.

Posted: Sun May 01, 2005 7:27 pm
by LUXon37s
Any idea on what ratios are out there ?

Posted: Sun May 01, 2005 7:32 pm
by carts
60 series have 4.1's standard.

Turning 36's with standard ratios with a stock 2h will be hard work for the old diesel, but not impossible.

It will be a dog at higher speeds, but first gear on road will be more usable.

I think 4.88's are available.

Posted: Sun May 01, 2005 10:20 pm
by A1
Yeh im also interested in this ................they had 4.11 that i know of and i thought u could run the rare 6.1's aswell .....not a hundred percent wat they were outta ..mm stouts sp ???



where r these 4.88's from ??

Dan

Posted: Mon May 02, 2005 9:17 am
by dumbdunce
you can get 6.2:1 out of older stout utes, which is a cheap crawler if you can get them, but be aware this is almost a 50% reduction in ratio, so your rpm will go through the roof for anything over 80km/h even with the 36's. 4.30, 4.56, 4.88 and 5.29 are all available aftermarket but can be expensive - budget about $800 per diff fitted for new gears. for similar $ you can get transfer gears that give you much better low range and a slight reduction in high range, with the added dual benefit that you keep your dime-a-dozen 4.1 diff gears which are stronger and cheap.