Page 1 of 1
turbo boost
Posted: Sat May 24, 2003 1:37 pm
by Ruggers
i have just check my boost on the turbo, and at 4000 rpm its only going to 1 - 1.5 psi i was hoping to get the boost higher and coming in at a lot lower rpms. does anybody know how to achive this i thught about a boost controller but this would only work if i was getting maxium boost to start of with. the turbo is from an aftermarket kit that i got from the wreckers. and i have tried disconneting the waste gate but it makes no difference. should i just ring up the wrecks and get my money back i had a 30 day warranty and its only been 20 days. thanks for any help chris.
Posted: Sat May 24, 2003 3:06 pm
by NICK
what type of engine/turbo?
are there any leaks in the system?
NICK
Posted: Sat May 24, 2003 3:51 pm
by Juzza
We need much more info to give u any sort of answer on this one.
Type of vehicle and engine, brand and condition of turbo system would be a good start.
Posted: Sat May 24, 2003 5:23 pm
by murcod
If it's got the standard type built in waste gate then check it hasn't seized in the open position. Also try to spin the turbo inlet impellor with your fingers to make sure it hasn't seized.
Posted: Sat May 24, 2003 5:30 pm
by bj on roids
you might have broken a shaft or your exhaust wheel could be up the duff
something is definitely wrong?!?!?!
Posted: Sat May 24, 2003 6:29 pm
by purefmx
need engine & turbocharger specs... Hope it aint a schwitzer LB7 set-up. These were a primitive kit even when new, and surprisingly enough theres still some getting around. Boost is governed by the drivers foot, similar to a truck.
Basically check for any inlet leaks..would be the best bet, also check your boost gauge. If ya can get hold of another gauge,"T" piece of the existing line and check to see that both gauges read the same.
Posted: Sat May 24, 2003 6:47 pm
by Ruggers
its a 3b and the turbo i was told looks like a t3 hybird, im now getting boost when i drive but it only goes up to 4 psi so im going to get a boost controller. i guess i wasnt reving long enough for pressure to build up. by the you guys that have turbo diesel the 3b in particular what sort of boost did you's run. thanks for the help chris
Posted: Sun May 25, 2003 8:20 am
by bj on roids
4-7 psi is a good recommendation
to get more boost the motor wants more fuel, there is an adjustment screw but you are best to pay a turbo and tuning place, they can get it up to ten psi easily. i ran 17psi but had a very healthy motor and did not expect much of a life out of it.
Posted: Sun May 25, 2003 11:01 am
by NICK
murcod wrote:If it's got the standard type built in waste gate then check it hasn't seized in the open position. Also try to spin the turbo inlet impellor with your fingers to make sure it hasn't seized.
without the motor running, or it could be very very painful.
NICK
Posted: Sun May 25, 2003 11:09 am
by murcod
NICK wrote:murcod wrote:If it's got the standard type built in waste gate then check it hasn't seized in the open position. Also try to spin the turbo inlet impellor with your fingers to make sure it hasn't seized.
without the motor running, or it could be very very painful.
NICK
Sorry I thought that was obvious!
Anyone who needs to be told that shouldn't be lifting their bonnet.
Posted: Sun May 25, 2003 12:50 pm
by NICK
murcod wrote:NICK wrote:murcod wrote:If it's got the standard type built in waste gate then check it hasn't seized in the open position. Also try to spin the turbo inlet impellor with your fingers to make sure it hasn't seized.
without the motor running, or it could be very very painful.
NICK
Sorry I thought that was obvious!
Anyone who needs to be told that shouldn't be lifting their bonnet.
thats true, but often the fan looks like it isnt spinning and we become forgetful, really it is that simple for something to go wrong.
NICK