Outer Limits 4x4 Board

Hey all this is Dan and ive got a weber 32/36 to put on the zuk. Its just a std 1.3 with extractors and a 2inch system. I know i need to buy different jets for it and was just wondering what sorta jet sizes you guys run and recommend. So far the jets i have are primary/secondary are air correctors 160/170 idle 60/50 and main 145/165. These seem to be quite big compared to the few fellas i have talked to.
Any help to set this thing up would be great!
Cheers!

what jets you run will depend on what airfilter you are going to use.

if ya gonna use a ramflow then 160/170 air, 55/50 idle and about 120/127 mains should be ok
if ya going to use the standard airbox then change ya mains to 110/105.

this setup is ok on mine but it will vary depending on condition of engine and what exhaust you have.

also adjust ya timing to 12 degrees. there is heaps of info on the USA zook sites about webers that are really helpfull.

good luck