Outer Limits 4x4 Board

I have the old twin point dizzy on my Chev 350 & was thinking about replacing it with a newer electronic type but i dont know much about whats available & where to get them.

Just after a basic (cheap) one without all the extra race ignition etc.

What do you guys use & were to buy from ?

repco sell mallory(SP?) setups , they guoted me around $350 for a HEI dizzy for my 308

i done a HEI on mine

just conect ya power and rev counter
rip out ya old coil and off ya go
as to where to get them over there i could not tell ya

I have procomp dissy in mine and no problems with it. Different ones for different applications including one with coil built into the cap.
http://www.procompelectronics.com

Available from sydney speed supplies not sure where else.

Might go & have a look at a HEI.

Did you notice any difference in revs/ power after installing one, is it worth it ?

ive got a vn 5 litre dissy on mine, (at least thats what the cap and rotor are from) just runs the sensor to an ICE ignition module. I didn't put it there so i don't know if its a straight swap though.

Give Sam ring at "Enginemart"
Deals only in Chev stuff and is well priced.

0403 741 708

or

03 8790 3402

email.....
enginemart@hotmail.com

And are they worth upgrading ???????
HELL YEAH !

I will look them up, thanks.

Contact Petroject for a price. I think they qouted about $250 for an electronic ignition setup for my old 253.

Cheers, Dean

just bought one for the boat. s/h with all new moving parts and cap $180 for a delco hei. you need new leads as they are different budget $100 for these. superformance in south brizvagas

cheers bru

I recently read on another forum where someone asked what the $250 Procomp HEI ones are like and not one positive response. I'd get a better brand HEI though.

Ring your local yank car wrecker, should be able to pickup a chev hei for $50 or so.