Outer Limits 4x4 Board

I am looking at putting 80 series diffs under a bundera. I have searched other posts but they give no specifics on the job.
1. Has anyone on this board done it. was it fairly straight foward, do you have pics.
2. Are the original control arms on the rear diff used or are new ones fabricated to suit and where were they attached to on the chassis
3. How far were the spring mounts moved on the front and rear diffs (inwards i assume).
4. What control arm was used on the front diff, was it the standard 80 or the bundera control arm.

Any other information that might be helpful to the task would be greatly appreciated.

Mark from Marks 4WD adaptors done his own Bundy and was covered over a few issues of 4X4 monthly id say about 1 1/2 to 2 years ago.

Wally

4wd monthly did an article on this a while ago.
no.70 and no.71
september and october 2004.
pretty good read

Does 4WD Monthly offer any back issues?

Dave

beanz2 wrote:Does 4WD Monthly offer any back issues?

Dave

yes they do. try www.4wdmonthly.com.au

beanz2 wrote:Does 4WD Monthly offer any back issues?

Dave

Yes but I have a larger range at my place and more Send me the location of your crate
Im sure Ill have sept and oct 2004 and more

Thank you , sir. I've been wanting to fill up all the available space in the crate, LOL.

Check your PM.

Dave

Hi 80 nsw
What year is your Bundy
The later Bundy's , ie high pinion 91 on?, have the same front arms as an 80
J Top

haven't purchased yet, doing the deal on sat. It is an 85 model, only had a quick look over as i'm only really after the body and chassis, but i thought i saw a high pinion, does this make sense, did the earlier ones have a high pinion front?