Outer Limits 4x4 Board

just about to install a new manifold gasket and noticed that it has been bent at some stage. is this still ok to install???

I can see light through the two sides of the gasket.

and also, does it matter which side goes on the manifold ??

It's stuffed. You'll have to buy a newy. Generally speaking most exhaust gaskets will go on either way but the port & bolt holes may not line up exactly so test it both ways paying close attention to the port areas for correct fit.
Cheers.

exhaust gasket??? i always put some high temp silastic on both sides of exhaust gaskets just to make sure they seal. it doesn't look to bad just use it.

If its not too big a job to fit then use it and see how you go (it should be ok though) if its a nightmare to fit then buy a newy just in case!!!

as said check all the holes etc line up properly and bung it on!