Page 1 of 1
reusing old perches n plates
Posted: Tue May 31, 2005 4:58 pm
by Spartacus
is it be a bad idea to reuse the removed diff perches if still in
good condition?
or should i replace the perches, u bolts, n plates all in one go?
Mull
doing a diff swap n gaurantee the perches need to be moved
Posted: Tue May 31, 2005 11:33 pm
by V8Patrol
Uboltz and fisher plates should be fine.....
Check for thread damage on the Uboltz after ya get em off
As for the pearches....how are you going to remove them ???
Oxy,
grinder,
More n likely they wont survive the removal that well so it may pay to make up another set.
Kingy
Posted: Wed Jun 01, 2005 4:21 pm
by Spartacus
grind n air chisel the perches off.
$45 for perches at superior engineering
Posted: Wed Jun 01, 2005 4:23 pm
by -Mick-
get new perches I reckon. Even if they survive the chop they'll be ratty.
Mine were when I did my diff swap.... but that was redneck engineering
Posted: Wed Jun 01, 2005 5:24 pm
by HEY CHARGER
Piss the perches off , dont waste your time ..