Page 1 of 1
					
				Mq P motor update to ???
				Posted: Sun Jun 05, 2005 7:00 pm
				by ron
				hi all 
i am looking to update my mq patrol with a later model motor like a rb30?. 
is there any difficulty with the exchanging of the motors? 
will the bellhousing fit?? 
any other suggestions?? 
thanks 
for your help 
ron
			 
			
					
				
				Posted: Sun Jun 05, 2005 7:13 pm
				by Screwy
				unfortunatly no other engine ( straight 6 cylender ) will bolt in anything close to easily expect L28 mq motor and its worse than a P40 
 
 
U could get an injected petrol L28 from a z series nissan and it would go in easily enough with bellhousing switches etc.....
short of that mate, id be going a V8.
no one makes the adapters etc from the older motors to the newer 6 cylender ones, it would be a one off and big $$$$
screwy
 
			
					
				
				Posted: Sun Jun 05, 2005 8:39 pm
				by ron
				thanks mate
what about if we change motor and gearbox??
ron
			 
			
					
				
				Posted: Sun Jun 05, 2005 8:41 pm
				by Beastmavster
				Then you're issue is getting it to mate up on the transfer case end. :(
Plenty of options if you're replacing both engine and gearbox - from V6 commodores and EFI 4 litre falcon (cheap options) to v8's... but remember getting everything together at the transfer case end then becomes your issue.
			 
			
					
				
				Posted: Mon Jun 06, 2005 3:46 pm
				by ron
				hi
any suggestions as to what might be suitable?
we were thinking about a RB 30 like in the commodore or the skylins.
thanks
ron
			 
			
					
				
				Posted: Mon Jun 06, 2005 4:29 pm
				by MARKx4
				Dellow automotive has a adaptor for the ford 6cyl by memorie and thats the only one i know of. 

 
			
					
				
				Posted: Mon Jun 06, 2005 8:18 pm
				by ron
				hi
thanks mate
will check into them tomorrow
ron