Outer Limits 4x4 Board

hey, well a friend of ours made a rear bar and some sliders for our patrol..the rear bar is similar to kaymar..except they aren't available yet

so heres some pics: what do you's think? if you want a bar or similar made..pm me for the nubmer..





same hole- different car

I saw these at LCMP on the weekend. Very well made. I'm no welder, but they looked very neat.

The side steps are bolted to the chassis - not welded and no holes drilled. They sure do look strong. Thinking about a set for my Patrol (dual battery and Engel first though - priorities). There were quite a few getting around with his handy work attached.

I also met the guy who made them. Seems like a nice guy.

gu4800 wrote:I saw these at LCMP on the weekend. Very well made. I'm no welder, but they looked very neat.

The side steps are bolted to the chassis - not welded and no holes drilled. They sure do look strong. Thinking about a set for my Patrol (dual battery and Engel first though - priorities). There were quite a few getting around with his handy work attached.

I also met the guy who made them. Seems like a nice guy.

hmm, were you camped near us or something? I'm guessing you could of been with the Wizard gang?

I was camped down near you guys, but further down. Not with any club, but saw Pete up at the toilet block and had a good look there (at his car!!!).

I also saw you come up the hill with the massive ruts and had a good look at your side steps when you parked it - saw the "Barwork by Peter" label on the step.

Ok sick you probably saw me driving up camp road? did it look like a 16yr old driving?

Sure did. We could tell it was you Ryan..................the only gay 16yr old there.



I didn't even go up on the weekend

HOW HAVE YOU MODIFIED THE SUSPENSION TO MAKE IT WALK LIKE THAT??

shep3633 wrote:HOW HAVE YOU MODIFIED THE SUSPENSION TO MAKE IT WALK LIKE THAT??

7 inch wizard lift
3rd's production arms..
rancho shocks..
wizard trailing arms..
...