check out this Disco on land rover world site...
Posted: Thu Jun 16, 2005 9:38 pm
It is a Scorpion Racing Kit with heaps of rear flex and none in the front...
Outer Limits 4x4 Board
Aussie Hardcore Wheelers
https://outerlimits4x4.com.au/
check out this Disco on land rover world site...
Page 1 of 1
Posted: Thu Jun 16, 2005 9:50 pm
boring
It is a Scorpion Racing Kit with heaps of rear flex and none in the front...
It is a Scorpion Racing Kit with heaps of rear flex and none in the front...
Posted: Fri Jun 17, 2005 11:37 am
and maxidrive portals...... not so boring.
Posted: Fri Jun 17, 2005 11:41 am
the flex isnt that super, the portals are 
all in all it looks pretty
i give it a 7/10
all in all it looks pretty
i give it a 7/10
Posted: Fri Jun 17, 2005 10:12 pm
That rear coil sure looks like it is doing it's bit for wheel loading. I'm guessing it's pretty empty - i bet with some weght in the rear that drooped front wheel would be heading well skywards!
I do like the look of it very much though - must be the colour... I think mercedes used something similar circa 1985 on the 300GD
I'm guessing it's pretty empty - i bet with some weght in the rear that drooped front wheel would be heading well skywards!I do like the look of it very much though - must be the colour... I think mercedes used something similar circa 1985 on the 300GD
Posted: Fri Jun 17, 2005 10:35 pm
Yes...just the portals would do me fine.
4" lift....portals....44" boggers
.............
Oops, sorry guys. Was off dreaming about my wish list.
Micka.
4" lift....portals....44" boggers
.............Oops, sorry guys. Was off dreaming about my wish list.
Micka.
Posted: Sat Jun 18, 2005 9:58 am
please tell me the point of the rear disconnecting if it does this the only weight on the ground on that wheel is only the weight of that wheel, axel tube and rubber is this enough for go foward????
it does look good but is it good it's the old good from far but far from good
it does look good but is it good it's the old good from far but far from good
Posted: Sat Jun 18, 2005 10:33 am
gee guys, a tad picky arent wee?
its a friggin modified disco that looks good !
its a friggin modified disco that looks good !
Posted: Sat Jun 18, 2005 9:57 pm
yeah but until SR start catching up with what works rather than "borrowing" from others and charging heaps for old tech that was a learning process........
serg
serg
Posted: Sat Jun 18, 2005 11:10 pm
SCRAP IRON RACING
Posted: Sun Jun 19, 2005 8:01 am
For what it's worth, I'm pretty sure that disco was outfitted by Outback Imports in France (it's their logo on the door) and they work with Equipe4x4, which is the original that SR copied, after selling the original for a while. Outback Imports is also the European distributor of MDE stuff.