just bought an X9 superwinch second hand but it has never been unspooled. however when it was pulled out much of the wiring was disconnected. with the female plug end that the hand control goes into there are three wires, black with female spade fitting on end, green with femal spade fitting on end and a white wire with an eye fitting on it. i The black and green wires obviously go to the male fillings on the solenoid but where does the white one go? is it an earth or does it supply constant power or something? Any help would be appreciated.
Thanks wes.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
wiring info for X9 superwinch
Moderators: toaddog, TWISTY, V8Patrol, Moderators
wiring info for X9 superwinch
My mind is like a steel trap....quite dangerous because i forget where i left it.
Who is online
Users browsing this forum: No registered users and 0 guests