Page 1 of 1
fitting adjustable panhards
Posted: Tue Jul 05, 2005 2:12 pm
by Madmac
well following my previous thread ive lashed out and bought an adjustable tough dog item for the rear, ill buy the front one next week. is there any trick to fitting them. is their specific points i should take measurements from to determine what length i should adjust it to?
Posted: Tue Jul 05, 2005 2:39 pm
by bazzle
With normal load measure between tyre wall and inner guard/chassis rail. Adj so lboth within 5mm or so.
Bazzle
Posted: Wed Jul 06, 2005 4:30 pm
by Madmac
thanks for that bazzle, im going to have a crack at it now, got some 3rds trailing arms too, all sounds simple enough
Posted: Thu Jul 07, 2005 10:45 pm
by toughnut
Yeah. real easy to fit.
Posted: Fri Jul 08, 2005 9:58 am
by Area54
bazzle wrote:With normal load measure between tyre wall and inner guard/chassis rail. Adj so lboth within 5mm or so.
Bazzle
Perfectly acceptable method.
If you are looking for that micro adjustment (perfectionist) you can use a plum bob to align the diffs, park the rig on flat level concrete for best results though.