Outer Limits 4x4 Board

im really loving this 24 thing....

so one of the mq's has flat batteries again - im too lazy to pull the batteries and recharge them.

i have another (working) 24v mq....

can i run 2 sets of jumper leads? how do i connect them?

from one batt' only

I've found its easier to clutch start my swb safari, just drag it along then clutch it, easy as

If you have another 24v vehicle, just hook the jump leads from the +ve on one battery and the -ve on the other to the same on the disabled car. (obviously dont connect to the two terminals that are connecting the 2 batteries)

If you have a 12v vehicle to jump it off, measure the voltage of both batts on the disabled vehicle and hook the jump leads from that battery to the one on the running car.

does that make sense?

This might help (or it might not, lol)

you only need 2 jump leads (red and black in the pic)

and if you need to jump it off a 12v vehicle (it can be done but is easier if one battery still has a bit of life in it or if they are both only slightly low)

I cant see a problem useing the other 24 volt to jump start . As long as you put 24 volts to the output lead ( starter motor) it should work no dramas.

Cheers

When I had a 24v system in my old nissan I found I could jump off a 12v battery only hooking up to one of the two in my car. If it doesn't work on one hook up to the other instead.