Page 1 of 1
Fitting 75 series landcruiser bullbar onto bundera
Posted: Mon Jul 11, 2005 10:34 am
by Rock Wallaby
Hey guys,
just got a couple of second hand 75 series bullbars at work and want to know how easily it is to fit them on a bundera? is there any drilling or can they not completly fit at all?
regards
Dan
bullbars
Posted: Mon Jul 11, 2005 7:29 pm
by Gibonator
just mesured me bundy in the dark, was 615cm between chasis rails so i dont know how acurate it is. but the landcruiser manual says the chasis 630 apart so maybe it might, just depends on the dark
Posted: Tue Jul 12, 2005 7:44 am
by V8 Middy
My Middy had a modified 80 series Bull bar fitted when I bought it. The cross peice blocked the headlight. Sounds a little off topic but my point is that if it fits the chassis rails, a body lift can solve the headlight problem more easily than trying to weld new mounts... and you have a body lift!
Posted: Wed Jul 13, 2005 8:01 pm
by DNA Off Road
Drag out the tape measure and do some cross checking yourself – I have been told [could be some BS too] that measurements can differ a significant amount up to 30 mm. My 75 is 726mm to the outside of the frame rails for what it is worth…
Posted: Thu Jul 14, 2005 7:52 am
by Bundytime
it will bolt stright on!!!! i have one on mine!!! its my third bundy and they have all fitted. the only difference is the length of the front guards and bonnet but most other 7# series parts will bolt onto bundys.
Posted: Fri Jul 15, 2005 6:09 am
by harvey
i asked ARB if their 75 series bull bars would fit on my 70 series and they told me 'yes'. so i'd be surprised if it wasn't a straight swap over.