Outer Limits 4x4 Board

hey every 1.i have a mav shorty and im trying to fit 35's to it so far i have a 3" suspension lift and a 2 " body lift would this be enough to fit the 35's or will i have to chop my guards.is so how hard is it to weld and so forth and how much do i have to cut? any help would be greatly appreciated.

Do a search on the topic. It has been discussed about a million times before.

With that amount of lift and front control arm spacers, you should be find. Get a landcruiser offset for the rims though

Ive got 35's on my shorty with a 5" spring lift and I get rubbing at full flex. Nothing major, just sometimes I have to screw my bunnings flares back on

bunning flares hey i got them from arb thank you

but with 35's you will get scrubbing at full flex with any height lift unless you chop your guards out if you get front arm spaces you should be ok up front at the rear though just get out the grinder i know guys who run 2 inch spring and 2 inch body with 35's

i run 35x11.5 simex's with about 2 body + 2 suspension, guard cut and front arm spacers, longer lower arms and quarter panel cut, low and nasty

A friend runs 35" claws on his shorty, and has room for 37's....
Has 2" body, & 4" susp. lift ( longer rear arms), and had a minor guard chop runnin flexy flares. Never rubs when articulating.