Outer Limits 4x4 Board

well mines dead! its gone to a better place, the rings are stuffed

what motors can i fit without spending fortune's on adaptor plates??? do vl or skyline motors fit? or am i stuck with just the L28 or buying a new car

I was at Cheezy racing the other day and he is fitting a new Gen111 into a MQ ATM.

i was there this morning, but thats abit expensive

Tube Works wrote:I was at Cheezy racing the other day and he is fitting a new Gen111 into a MQ ATM.

That is a mate's car, did you hear what he paid for the motor and auto complete?

L series have been covered before - the L28 patrol at 88kw is about as low spec as it comes.

Due to method of testing used over the years the spces may vary slighlty but here's the L series replacements....

L24 240Z 114kw and L24 skyline EFI similar

L26 260Z 123kw C260 111kw

L28 280Z 138kw Skyline & C280 111kw

L20 turbo efi exist as well, as do the L20 triple carb jobs.

My recommendation is to go more modern though - RB series supposed to fit to L series box with RB bellhousing buit no personal experience.

Given teh price with RB20 turbos... 140-160kw depending on spec....

would have been my plan in an MQ.

Other good option ED onwards falcon 6 with 144-157kw Marks adaptors and Dellow doa kit for them.

if i had no budget, i would use a RB30 blok with a RB26DETT head of a GODZILLA GTR, two massive turbos and a waterto air intercooler. That thing would pop monos on a long wheel base.

GQ4.8coilcab wrote:if i had no budget, i would use a RB30 blok with a RB26DETT head of a GODZILLA GTR, two massive turbos and a waterto air intercooler. That thing would pop monos on a long wheel base.

would be good for wank value, but would lack down low grunt tryin to spool 2 snails..

bogged wrote:

GQ4.8coilcab wrote:if i had no budget, i would use a RB30 blok with a RB26DETT head of a GODZILLA GTR, two massive turbos and a waterto air intercooler. That thing would pop monos on a long wheel base.

would be good for wank value, but would lack down low grunt tryin to spool 2 snails..

Yeah but who sticks 2 massive turbos on there?

Either two smaller sequentials or one massive one for wank value.

Setup for response and not outright power the 3.0L block has a very nice torque curve.

Personally I wouldn't want to take an RB off road, I had enough troubles with them keeping it on the road (out of the mud etc).

Carby V8 ftw.

look guys, it is if i had no money nd in the extreme winch challenges u barely use low range, lets be realistic, put in a 4.8 with a nice sized turbo nd a water to air intercool, nice torque all the rev range

adam.s wrote:

GQ4.8coilcab wrote:if i had no budget, i would use a RB30 blok with a RB26DETT head of a GODZILLA GTR, two massive turbos and a waterto air intercooler. That thing would pop monos on a long wheel base.

Yeah but who sticks 2 massive turbos on there?

that was the original suggestion

i'm really glad this thread has helped me

well as it turns out my choice is either L28 or L28 so its v8 time i think

Big Red Toy wrote:i'm really glad this thread has helped me

well as it turns out my choice is either L28 or L28 so its v8 time i think

have you priced a Marks adapters kit for a injected 383 chev conversion yet?

You're in melbourne go speak to one of the Zed workshops and see how much power they can get out of your L28 and how much capacity they can go to... you will get a massive shock.

Beastmavster wrote:You're in melbourne go speak to one of the Zed workshops and see how much power they can get out of your L28 and how much capacity they can go to... you will get a massive shock.

...but not without forced induction ?

injected 383, that'd be nice . looks like i might be going 308 would be nice to pick up an injected motor but not likely unless someone has a written off vn ss with motor still intact

yeah i know about modding the l28's, i've looked into it, but not without turbo & i have worked out i should be able to go v8 without too much hassle thanks to some help

this sounds nice :
tradingpost....
Holden 308 Race engine, Motec, dry sump, direct port nitrious, 540hp, too much to mention, $20,000ono

If just going a V8.
Are you planning on doing any long trips with this thing. As might be worth just running the thing on straight gas and have carby in the back for when you fark up and run out of gas.
Oh will need a small petrol tank to.

Big Red Toy wrote:this sounds nice :
tradingpost....
Holden 308 Race engine, Motec, dry sump, direct port nitrious, 540hp, too much to mention, $20,000ono

There's a bloke in the next town with a 454 for sale......

You'll need a couple of GOLD visa cards and a jigsaw.......

the blower wont fit under the bonnet of a MQ

Big Red Toy wrote:injected 383, that'd be nice . looks like i might be going 308 would be nice to pick up an injected motor but not likely unless someone has a written off vn ss with motor still intact

goto that parts search site, put in that you are lookin for front cut VN SS, or later... see how ya go, its free.

googled for
online parts search wreckers


www.partslocator.com.au
http://www.autorepairers.com.au/online_parts.htm
http://www.partsonline.com.au/Part_request.asp

how about a full injected 308 with t700 auto from the states? can do one for about $4000.00

Tiny wrote:how about a full injected 308 with t700 auto from the states? can do one for about $4000.00

Search the tradingpost they have commodore injected 5ltr's in there nearly every week. Start around or just over $2000 for a VN motor and upto $4500 for the VT or HSV engines.

bogged wrote:

Tiny wrote:how about a full injected 308 with t700 auto from the states? can do one for about $4000.00

he he he love the img

ok, well the story so far.

1/ Bellhousing on its way to suit a chev turbo pattern.

2/ Was going to get a efi 350 but more $$$ than i thought, i could get it for $3k with loom & all bolt on bits such as alternators & ps pumps so not so bad price but a bit much for what i want to spend

3/ I'm open to offer's suggestions on motors...... even u kingy

i have heard of ford 6's bolting into MQ's pretty easily and they go alright with a few minor mods

Nissan VH45

reminder that i have a bellhousing ordered

CHEWY wrote:Nissan VH45

mmm

hottiemonster wrote:

CHEWY wrote:Nissan VH45

mmm

Nah turbo XR6T better than vh45. as it only just spins wheels in 3rd low(35's).