Outer Limits 4x4 Board

Posted: **Fri Jul 22, 2005 11:31 am**

anybody know where i can find a bull bar for a US Rocky?

Posted: **Fri Jul 22, 2005 11:40 am**

The best people for you to talk to are Toyhatsu and SimplyPV. They are both from the US and would be able to help you.

Posted: **Fri Jul 22, 2005 1:35 pm**

i havent seen any bull bars made commerically in the u.s. only ones i have seen were the factory a-bars. from what i have seen so far, all bull bars have been custom made? i had mine made. not so sure about kents (toyhatsu) so hopefully he'll post in here with more info?

Posted: **Sat Jul 23, 2005 8:43 am**

Mine is fabbed also. I believe that there are several places that sell ARB products, besides the air locker, on the internet located in the US. You might contact one of them and see if they would order one for you. We don't have any roo's to bash over here

The only other thing is to try some metal fabrication shops.

Posted: **Sat Jul 23, 2005 8:45 am**

Toyhatsu wrote:Mine is fabbed also.

How much did that indicator mounting system cost? Are they the original lenses, if so were they hard to fit?

Posted: **Sat Jul 23, 2005 9:46 am**

r0ck_m0nkey wrote:
Toyhatsu wrote:Mine is fabbed also.
How much did that indicator mounting system cost? Are they the original lenses, if so were they hard to fit?

Haha...yes they are genuine Daihatsu. I have been meaning to weld some tabs on there and screw them on. I didn't use that cheap plastic electrical tape but went all out and bought and bought the expensive cloth kind

Hey, it works and they are functional.

Posted: **Sun Jul 24, 2005 11:30 am**

This bull bar/winch mount/brush guard is a aftermarket unit mounted on my 1988 Dodge Raider. There doesn't appear to be a manufacturer's name anywhere on it. The basic design is very versatile and it could be made to fit many different vehicles by altering the mounts. There is a shop in Oakwood, GA who told me he could duplicate this mount for about $400.00. Welding it together rather than making it bolt together would make it a bit cheaper and faster to produce.

Email me if you want his contact info, or go to the vendor section of www.southernjeeps.org and look for BigCheese or CW Design.
bruce@varminthunters.com

Posted: **Sun Jul 24, 2005 2:56 pm**

Thanks. How much for fabrication? I saw the $400. Anybody else?

Posted: **Mon Jul 25, 2005 11:23 am**

got mine done for $250 u.s. but then again a good buddy of mine was a welder and only charged me $10 an hour... used 1/4" thick steel tubing for the job. ran it into trees and the like and only suffered paint scratches!

Posted: **Wed Aug 03, 2005 1:47 am**

found chrome A-Bar from local yard for $125. Really helps appearance. Thanks everybody for input.

Outer Limits 4x4 Board

Bumper bars in the US?

Bumper bars in the US?