Page 1 of 1
Temp Sender Thread Specs
Posted: Fri Jul 29, 2005 2:35 pm
by Mudzuki
Anyone know the thread specs of the standard temp sensor?
Got to get a T adapter to fit an aftermarket guage.
Cheers
Posted: Fri Jul 29, 2005 2:39 pm
by nicbeer
Post up when ya get the guage and t piece as mine is crap.
I got one from the zook dealer and now it reads too low. apparently there are about 3 similar/diff ones, although all same tap/thread.
cheers
Posted: Fri Jul 29, 2005 3:17 pm
by Pinball
Can tell you how to test and resistance readings, but not thread...
bugger, won't cut and paste.. Sigh
50 degC 133.9 to 178.9 ohm
80 degC 47.5 - 56.8
100 degC 26.2-29.3
hope it's helpful
Spock
Posted: Fri Jul 29, 2005 3:28 pm
by nicbeer
Pinball wrote:Can tell you how to test and resistance readings, but not thread...
bugger, won't cut and paste.. Sigh
50 degC 133.9 to 178.9 ohm
80 degC 47.5 - 56.8
100 degC 26.2-29.3
hope it's helpful
Spock
Sweet, thanks.
How do you measure the resistance? from body to lug?
Posted: Sun Jul 31, 2005 9:36 am
by Mudzuki
Anyone?
Posted: Mon Aug 01, 2005 3:31 pm
by Pinball
tab to "nut" of switch, or body
PM me with email and i'll send PDF
Spock