Outer Limits 4x4 Board

ok i have started my conversion.

materials

5 mm ply

bolts and nuts

high build primer

final coat paint

2 rally spec air vents

vinal

thin open cell foam

i'm using the original sunroof fixing points so it's fairly easy to remove and i'll post pics tomorrow when i start fitting the vents and fit the fixings.

after i have got it fitted i'll start getting the lines right so it doesn't stick up and ruin the lines of the car (i know i'm being a pansy). any way look forward to tomorrow when it realy gets started and i'll start the how to guide

Matt

pics now

nice work.
where did you get the vents from and how much $$$$

also how much air flow do they give and any help with dust???

thanks

they were $69 ea from rev race gear but if you look around you'll probly find them cheaper.

i have only tested them at 60 kph on tarmac so i don't know about dust but they are ment to help.

and the air flow was good at 60 kph at 100 it might be too much

Matt

I take it you removed the sunroof glass/metal and installed the plywood. From memory, to be CDDA compliand for a time trial event you 1. can;t have a sunroof, 2. need at least 2mmsteel or 3mm alluminium as over head protection....just a thought.

Greg

A12 wrote:I take it you removed the sunroof glass/metal and installed the plywood. From memory, to be CDDA compliand for a time trial event you 1. can;t have a sunroof, 2. need at least 2mmsteel or 3mm alluminium as over head protection....just a thought.

Greg

thanks for that, if i ever get in to comps i'll weld in a bit of steel.

Matt