Outer Limits 4x4 Board

Hi guys, anyone know how to wire up tune port injection on a small block chev, i have a book that gives a rough idea but would rather someone that knows what they are doing to do it if someone wants a bit of backyard work.

Are you running MAF (Earlier) or MAP (Later) sensors.

I have made and ALDL cable and have some software for monitoring sensors, I have a couple of wiring harnesses and can easily get a complete after market one if required.

PM or call 0429 160 709 if you need some help or assistance.

We have TPI spares and complete kits on the way from the US right now.

Wiring is fairly simple as long as your current wiring is fairly (clean), make sure you have the correct manifold for your heads as they do differ slightly.

Have Fun

I should add that if you send me the ECU model number I will be able to make you an ALDL cable and send you the link to download the software.

Hardest Part of the setup is making sure all the sensors are working as they should !!

If your ECU is a factory one it may also have a speed sensor which either needs to be fitted to you car or you can re-program the chip to ignore/compensate for the lack of speed sensor.

Hi, the numbers on the ECU are serv no 1226870, then it has 860031- M520869865 and then 16050031. It is off a 85 model trans am. I got the set up from the states and have just finished rebuilding my motor and would like to get the injection up and running. Thanks for any info.

Tony.