Page 1 of 1
any probs with a 2" body lift on a bundy
Posted: Tue Aug 16, 2005 10:07 pm
by evanstaniland
hey i have a 1986 bundera with a 1 1/2 suspension lift and i have got a set of 2" body block sitting on my bench i was wondering a couple of things
1. do many things need to be altered like gear levers etc
2. will it make a dramatic change to the centre of gravity or is it just a slight change
cheers
Evan
Posted: Tue Aug 16, 2005 10:29 pm
by big bundy
Posted: Fri Aug 19, 2005 4:56 pm
by evanstaniland
i was taking out the bolts the other nite and i cant seem to get the rear bolts out due to the bolt not lining up with the hole if anyone who has done a body lift on a bundy can you pls help
cheers
Posted: Fri Aug 19, 2005 6:13 pm
by Bundy_Harry
Those rear bolts can be a real pain, perseverance is your best asset, hit both ends with a bit of WD40 or similar. These are the tools I used when I removed mine
Tops side
- Socket wrench
- extended socket drive
- universal socket bit
- appropriate sized socket
Bottom side
- appropriate sized spanner or wrench
then just work the bolts from there.
The majority of bolts in my Bundy were caked with dirt and grit in the sleeves, once the bolts were loosened the gentle persuader (aka Hammer) was need to remove them.
yeah so just keep at them and you'll eventually get them out
Posted: Sat Aug 20, 2005 2:49 pm
by evanstaniland
thanks Bundy_Harry for that info
when you did your body lift did you have to change anything like extend your gear stick etc
cheers
Evan
