Landcruiser vacuum controlled transfer case back to manual
Posted: Thu Aug 18, 2005 10:34 am
Has anyone coverted a vacuum setup back to the manual L selector? Does the front casing and selector shaft need to be replaced?
Outer Limits 4x4 Board
Aussie Hardcore Wheelers
https://outerlimits4x4.com.au/
Landcruiser vacuum controlled transfer case back to manual
Page 1 of 1
Posted: Thu Aug 18, 2005 4:38 pm
why
Posted: Fri Aug 19, 2005 1:20 pm
http://forum.ih8mud.com/showthread.php? ... nual+stick
has a little info.
selector shaft does need replacing, as well as some other bits
considering the parts you'll need, i rekon it would be easier to find a complete transfer with the manual shifting and swap that in.
has a little info.
selector shaft does need replacing, as well as some other bits
considering the parts you'll need, i rekon it would be easier to find a complete transfer with the manual shifting and swap that in.
Posted: Fri Aug 19, 2005 2:09 pm
Yep I did a little research on this too when I saw this post. Personely,I have a vacuum and quite like it.
Ok, if your going to do it your better off flogging the box you have now and get one that has had the shifter insince new. Your probably going to fins this the most economical method.
Ok, if your going to do it your better off flogging the box you have now and get one that has had the shifter insince new. Your probably going to fins this the most economical method.
Posted: Fri Aug 19, 2005 3:04 pm
yeah, too much hard work, it will be easier to rig up a vacuum solenoid or get another transfer. Thanks for the advice.
Posted: Sat Aug 20, 2005 1:41 am
Mick, you probably have a manual shift transfer lying about in the garage 
but other than replacing the 4WD shift fork shaft and drilling the case for a shift detent, I can't see it being much more work compared to replacing the entire transfer.
Dave
but other than replacing the 4WD shift fork shaft and drilling the case for a shift detent, I can't see it being much more work compared to replacing the entire transfer.Dave