Outer Limits 4x4 Board

Hey,

I'm after some pics of your Hilux exhausts. LN106 model. I have just had mine done and it's Sh!$%# !! to say the least. I got a 2.5 inch mandrel and it is sitting below the chassis rails where is crosses under the front driveshaft....

Would appreciate some pics of your rigs out there....So I can get mine rectified....

CHeers,
Daniel

dont cross under the front drive shaft, u run it right along under the cab and then go across to the other side just under the rear driveshaft

That's how mine was done spazbot. Just make sure they leave you enough room to get at your transfer case filler plug and your suspension bolts; never know when you will need to.

here is some of the one i just had done on my 4y hilux its 2 1/4

The IFS ones cross under the front driveshaft and is crap very easy to get hung up on and dent.
Much better as said to cross over after transfer case.

hay dude i have a 89 tray back single cab i found 2.5 was to big not anough back pressure but got them to run it about 2inc form the tray flore no way im getting cought up there just watch the spair it will burn if it is to close