Page 1 of 1

Body lift

Posted: Wed Aug 31, 2005 2:57 pm
by mangie
G'day
It would seem that the 40mm body lift I have is not going to be enough to stop rubbing my 35/11.5/15 Simexs, I'm thinking 60mm (about 2.3 inchs) is what I'm after. My question is, should I go aluminium or nylon and what grade nylon would I need? Any comments would be most helpful.

Posted: Wed Aug 31, 2005 3:07 pm
by HSV Rangie
aluminiumn or steel

Michael.

Posted: Wed Aug 31, 2005 4:42 pm
by Micka
Maybe some 30mm coil spacers will give you that extra bit of clearance.

The fronts are a pain to do, but it is a lot quicker and cheaper than redoing a body lift.

Micka

Posted: Wed Aug 31, 2005 5:07 pm
by Rangie ute on 38''
i had same problem so i put 30mm coil spacer in the rear and it works, that way your not exceeding the 2'' body lift (if that maximum rule still applies), lot less effort