Quick gearbox question.
Posted: Sat Sep 24, 2005 11:32 pm
Just wondering, is there any way of telling the condition of a gearbox while out of the car. I just swapped over my gearbox cause I thought it was better than my one, and now it's crunching 1st and 3rd. My dad said that should be the synchros. I wanna put the old one back in but I don't know whether it's noisy or not (shot bearings). Is there any way of telling before I swap them over?
Also, very important question. For as long as I can remember, when lifting the clutch in neutral the car sounds different. In neutral with the clutch in the only sound is that of the engine, but lift the clutch and on my old box I used to get a faint little noise. On the box I got now it's tonnes worst. Is this normal?
Oh also, by turning the input shaft, the output shaft turns immediately with little or no play, which is good, but I get a little rattle as I turn it back and forth, is this normal?
Also, very important question. For as long as I can remember, when lifting the clutch in neutral the car sounds different. In neutral with the clutch in the only sound is that of the engine, but lift the clutch and on my old box I used to get a faint little noise. On the box I got now it's tonnes worst. Is this normal?
Oh also, by turning the input shaft, the output shaft turns immediately with little or no play, which is good, but I get a little rattle as I turn it back and forth, is this normal?