Page 1 of 1
bomb proof skidplates
Posted: Fri Sep 30, 2005 3:03 pm
by toastmaster
i am going to fab complete sets of crawler skidplates for mitsu 4x4's
but i need the specs on the t-case skidplate for the gen 1 pajero auto tranny. so if i could get the length, width, bolt hole spacing, angle degrees and distance apart it would be very helpful
Posted: Fri Sep 30, 2005 10:42 pm
by Alex Kogan
Can't you just crawl under and measure for yourself. Guess you are hoping somebody've done the homework for you
I doubt that.
Of course, I'm Mitsu got all the info you need.
Bombprofness is overrated IMHO
Posted: Sat Oct 01, 2005 4:15 am
by Lordtrunks
I measured from bracket to bracket and got 19 1/2 inches(length) and about 6 1/2 inches wide.
Posted: Sat Oct 01, 2005 10:02 am
by toastmaster
i actually dont have the skidplates for gen 1 montero LT can you figure out the angle degree and space between?
Posted: Mon Oct 03, 2005 10:14 pm
by Loco
I am busy getting this type (see drawing ) laser cut for mine in 4mm mild steel, had the main front on done too and folded up to suit the shape.
The trans one and transfer case ones go from chassis rail to chassis rail (flat)and have 30% folds at the edges to prevent them digging in (angled upwards) and aalso vetinlation holes cut in randomly 1" diameter