Outer Limits 4x4 Board

How wide is an 80 series rear diff? Measured from the Wheel Mount Surface to Wheel Mount Surface.

I thought the 80 series WMS - WMS was 63" ...........





But i have been known to be way wrong




Dan

ill measure mine 2mora.

i knew i had the info

bubs wrote: the toy is still superior because it has an extra 5mm on the WMS

GQ - 1600 WMS
80 Series - 1605 WMS

from my UZN thread, i meausured this when I bought the GQ rear

ok well there u go Tony, saves me running a tape over mine thanx Bubs.

bubs wrote:i knew i had the info

bubs wrote: the toy is still superior because it has an extra 5mm on the WMS

GQ - 1600 WMS
80 Series - 1605 WMS

from my UZN thread, i meausured this when I bought the GQ rear

Was that with Disc Rotors fitted?

yes, on a 80 front

think he wants the rear measurement

CHOPZUKI wrote:think he wants the rear measurement

Yes im after the rear WMS-WMS. And before anyone replies they will be the same its unusual for the front and rear to be the same.

RUFF wrote:

CHOPZUKI wrote:think he wants the rear measurement

Yes im after the rear WMS-WMS. And before anyone replies they will be the same its unusual for the front and rear to be the same.

would it help to measure the 80 that i drive to work? thats if you dont have the measurements by then

From the RTA fact sheet;

80 series wheel track front (0 offset rims)- 1595mm

wheel track rear (0 offset rims) - 1600mm

That's easier than going and measuring for you.

slosh wrote:From the RTA fact sheet;

80 series wheel track front (0 offset rims)- 1595mm

wheel track rear (0 offset rims) - 1600mm

That's easier than going and measuring for you.

Thankyou.

so that makes a rear WMS of 1610mm and a front of 1605mm

needs to go to the FAQ

bubs wrote:so that makes a rear WMS of 1610mm and a front of 1605mm

needs to go to the FAQ

How did you work that out?

Looks like 1595 and 1600 to me

i see what you mean, hmm, aza never was good at holding the tape

I will check tommorow, I have 2 80 rears and a 80 front atm