Outer Limits 4x4 Board

glenn_c said it was ok for me to post some pics of his boost gauge and also of his rock sliders, so here goes









cookie monster

nice sliders ......is that 10mm plate under the rear?

Thanks Cookie,
The silders are made from 50mm x 25mm RHS, on the rear there are two pieces welded together to make 100mm x 25mm and best part is they work great.
Regards Glenn

Thanks Cookie,
The silders are made from 50mm x 25mm RHS, on the rear there are two pieces welded together to make 100mm x 25mm and best part is they work great.
Regards Glenn

Hey Glenn they look good. I assume the main sliders are from 50x25mm too? What type of checker plate is on top?

Also... what are the two bolts (?) I can see near the driver's door area?

Cheers,
Pete.

Hey Glenn they look good. I assume the main sliders are from 50x25mm too? What type of checker plate is on top?

Also... what are the two bolts (?) I can see near the driver's door area?

Cheers,
Pete.

Yep the main sliders are 50 x 25 mm inboard vary vertical and outboard horizonal. The bolts were for air tank but I changed my mind latter.
Regards Glenn

The top is just thin alloy checker plate screwed on the top for a step.

50 x25 but how thick 4mm?

glenn_c wrote:Thanks Cookie,
The silders are made from 50mm x 25mm RHS, on the rear there are two pieces welded together to make 100mm x 25mm and best part is they work great.
Regards Glenn

these r 25mm thick ????

yeh i rekon, thats exactly what i beent hinking ever since i seen them, that exhuast would typically be about 2" and those sliders are not half of that? is this correct glenn, are they 25mm????

dean

The back sliders are actualy 100 x 20 mm x 3 mm thick (the thickest you can get) the exhaust is 2.5 inch.
Glenn

yeh fair enough, thanks for that, just dont look that thick, they do look awesome though

dean