Page 1 of 1
pitman bar chassis mount and welding...
Posted: Sun Oct 30, 2005 7:14 pm
by Mousie
hey i have mannaged to break the chassis mount off the steel has split at the bottem of the chassis rail
is this ok to weld back on ?
cheers
Posted: Sun Oct 30, 2005 8:37 pm
by Ryan
hey dude let me know how u go with this as i need the same thing done on the front of my GQ
Posted: Sun Oct 30, 2005 8:41 pm
by Mousie
are you near campbelltown ? were welding mine back up and getting a bit of steel plate to use as reenforcemnt i`ll let u know how we go
the good old electric 130 amp welder should do the trick just nice
Posted: Sun Oct 30, 2005 8:48 pm
by ozy1
as this is a chassis, id be recomending a welder with a higher out put for better penetration, which will leave you with a much stronger weld, especially seening as thou you will need to weld verticle,
Posted: Sun Oct 30, 2005 9:11 pm
by Ryan
im in penrith but will go anywhere if its at the right cost lol
i need pretty much the same, welded and plated up then bracket welded back on, also need some strengthening round the steering box mount