Outer Limits 4x4 Board

Does anyone know if there is an aftermarket replacement for the fan hub on the 24 valve V6 engines or if the bearings are replaceable. I think the 3L Triton and 3.5L Pajs are the same. Got a price from local mits - $344 trade. Ouch. Tried Bursons where I got 99% of parts for work and play but not available.
Also the rubber radiator mounts. Any one purchased replaceable bushes to press into the upper radiator brackets.

Peter H

Yes there are replacement Powermax fan clutches available from Autobahn stores (about $130).
Davies Craig do them also but are around $180.
Not sure about the radiator mounts - I suspect these will have to be genuine

Sorry Frank, should have been clearer. I am referring to the hub that mounts the fan/pulley assembly to the engine.
Peter H

I would try the wrecker's. I don't think anyone would make that kind of alloy bracket.

Replaced one of these from a wreckers about 6 months back after spending an arvo trying to press out the old bearing with no luck. I'm sure if you had a big enough bearing press or are able to heat the unit you would be able to get the bracket and bearing apart, then source a replacement part from a somewhere like CBC.

Ah ok I know what your talking about now.
I priced the 3.0V6 one from Mitsu = $383 + Tax
He told me they are non seviceable (bearing cannot be pressed out) which is ludicrous for such a big cast bracket.
I'm pretty sure the 3.5V6 is a similar arrangement - fan belt drives radiator fan pulley which is supported by the flange/bearing in that bracket bolted to the front of the motor. The water pump is a separate part driven by the timing belt.
I'm afraid the only option would be genuine..............