Page 1 of 1
350 chev
Posted: Mon Nov 14, 2005 9:09 pm
by 3800zook
i want 2 put 350 chev in my nc pajreo swb can any 1 tell me if ther is kit i can use is it legel 2 put 1 in it qld
Posted: Tue Nov 15, 2005 1:39 am
by fool_injected
There was thread a little while back re V8 Paj conversion
From memory nobody makes a kit for this conv.
http://www.outerlimits4x4.com/PHP_Modul ... =body+lift
Providing the chev fits you will need to have custom engine mounts made
Marks 4WD Adaptors sell Holden V6 to Paj gearbox adaptors. I don't know if V6 and V8 have the same bolt pattern but if they do you can use this adaptor
Another alternative (stronger?) is to run the T700r (460LE) transmision with the pajero tranfercase.
I would be a little worried with breaking front CVs with the extra torque
cheers
wayne
Posted: Wed Nov 16, 2005 4:25 pm
by its fishi
There's a Gen 1 on ebay atm with a 253 Holden if that helps.
http://cgi.ebay.com.au/4X4-PAJERO-4WD-4 ... dZViewItem
Posted: Wed Nov 16, 2005 4:54 pm
by 4ePajero
I had a Chevy 4.3 V6 in my GenI. The 4.3 is a 6-cyl version of the 350 V8 (rear two cyls went missing).
The 4.3 fitted without bodywork mods, but I think you will have to do major mods to fit the longer V8 engine.
Width is no problem.
Posted: Sat Nov 26, 2005 11:14 pm
by dazzsbuggy
4ePajero wrote:I had a Chevy 4.3 V6 in my GenI. The 4.3 is a 6-cyl version of the 350 V8 (rear two cyls went missing).
The 4.3 fitted without bodywork mods, but I think you will have to do major mods to fit the longer V8 engine.
Width is no problem.
iv doing the same a 350 chev in my old paj