Outer Limits 4x4 Board

Have an aftermarket snorkel, bascially a large metal pipe bent in to the appropriate dimensions. I have nothing to attach it to the pillar with... does anyone know if there is a an aftermarket attachment available or if not can anyone suggest a suitable alternative?
Cheers

Do you have access to a welder as mine has tabs welded on

BJ

no I don't have access to a welder. And the snorkel pipe is clean... I was hoping someone had a nifty idea on how to mount it.. none of the Fourby outlets sell their mountings seperately, they all come as part of the bigger kit.

no I don't have access to a welder. And the snorkel pipe is clean... I was hoping someone had a nifty idea on how to mount it.. none of the Fourby outlets sell their mountings seperately, they all come as part of the bigger kit.

Take it to a metal shop and they can weld some tabs on it for you. Shouldnt cost more than $10-$20. Then you could attach it to the pillar. Id use tech screws or rivets cause they're easy to put on/get off. Remember to run a piece of v-shaped rubber or plastic around the hole in the guard aswell. Unless you like rust.

The other, somewhat bodgy, option is to secure the pipe using cable ties which would probably do the job but may suffer from vibration at speed.

Get some photos up when you're done.

Thanks for that, will do. If anyone could be so kind as to post some pics of how their snorkel is fitted that would be tops.
Cheers

and what if its a polished snorkel?
and the pipe itself is quite thin???

tassie40 wrote: If anyone could be so kind as to post some pics of how their snorkel is fitted that would be tops.
Cheers

Just Emailed you some pics to your hotmail address

BJ

BJ, you are a dead set legend. Thanks for the pics.