Page 1 of 1
IFS Hub spacers for Solid Axles (WTB)
Posted: Sat Aug 02, 2003 12:47 pm
by bj on roids
I want some, soon, where can I buy them???
Who has the best price?
What is the $$?
Are these in stock, or will I be waiting around ages? Do the kist fit perfectly?
Posted: Sat Aug 02, 2003 1:03 pm
by hypo
i got mine from Chaos4x4. i ordered them they turned up 2 days later
good price also as everything u need is in the kit (except the hubs & bearings)
Posted: Sat Aug 02, 2003 8:27 pm
by cbr
hypolux wrote:i got mine from Chaos4x4. i ordered them they turned up 2 days later
good price also as everything u need is in the kit (except the hubs & bearings)
So did I. Good quality I have had them installed for about 2 months.
Chris
Posted: Sun Aug 03, 2003 10:07 am
by NICK
Chaos is the place to get em.
NICK
Posted: Sun Aug 03, 2003 10:11 am
by POS
How much???
Posted: Sun Aug 03, 2003 6:13 pm
by hypo
POS wrote:How much???
i think i payed 280 inc freight ill have 2 dig out my recepit(sp?) so i can b sure
Posted: Sun Aug 03, 2003 10:00 pm
by Old Yella
Ben with the chaos wide track hubs,where do you bolt the spacers , is it in the disc & hub, or is it behind the stub axle
What do you need off the IFS hubs, did these cost much
I'll ring your mob tomorrow after work [daywork] cause I wanna see yah bout some parts
Rob
Posted: Sun Aug 03, 2003 10:12 pm
by hypo
Old Yella wrote:Ben with the chaos wide track hubs,where do you bolt the spacers , is it in the disc & hub, or is it behind the stub axle
What do you need off the IFS hubs, did these cost much
I'll ring your mob tomorrow after work [daywork] cause I wanna see yah bout some parts
Rob
the spacer bolts onto the back of the hub and then the standard solid front disk bolts 2 the spacer so that the disk runs in the same spot as normal.
the only bit needed from the ifs is the wheel hub itself u dont wanna use the ifs rotors coz u dont get as much pad - disk contact
Posted: Sun Aug 03, 2003 10:14 pm
by Old Yella
Cool thanks Ben
Rob
Posted: Mon Aug 04, 2003 7:47 am
by bj on roids
I talked to Richard from 4x4 engineering and he said he would do them so that i could bolt them on for $450 a pair. A bit exxy at the moment.
$280 for both sideds hypo?
anyone know if it is just the studs that line up the rotor? If so that is apparently bad as toyota have it so the rotor and hub are press fit. The press fit allows for less movement. Any thoughts? I am just curious!
Posted: Mon Aug 04, 2003 7:57 am
by cplux
when i had mine made, i had them made press fit and also the rotor bolted
to the spacer
Posted: Mon Aug 04, 2003 12:14 pm
by hypo
bj on roids wrote:
$280 for both sideds hypo?
yes mate ill have 2 fine my receipt 2 b sure but it wasnt any more than 300 a pair
Posted: Mon Aug 04, 2003 12:30 pm
by spazbot
currently listed on the chaos site for $365