Outer Limits 4x4 Board

hi i have an 83 hilux 12inch lift , 37 tyres ,i need to get my front tail shaft extended .i got a qoute of bercos to cut an extend my from tail shaft .to cut and weld $160.00 balance shaft $160.00 new extended shaft from toyota $287.00 h/d uni joint$60 total$667.00 is this any good if not which way to i go about it

ummm
i just paid 175 to get my rear driveshaft retubed and balanced plus 45 for a new uni here in melbourne

i say try somewhere else

matthew harris wrote:hi i have an 83 hilux 12inch lift , 37 tyres ,i need to get my front tail shaft extended .i got a qoute of bercos to cut an extend my from tail shaft .to cut and weld $160.00 balance shaft $160.00 new extended shaft from toyota $287.00 h/d uni joint$60 total$667.00 is this any good if not which way to i go about it

Paid $300 to get front and rear shaft extended and balanced for my MQpatrol in brisbane. I think they r having a go at u

pay nothing and it spins up just as good

Are the unis the same front and rear.??

If so I would get an other rear shaft and have it shortened. I don’t know if you need to have it balanced.

The rear shafts tend to be bigger and stronger.

Eric

Berco are pretty exxy, try this mob in Woggalong, they are pretty good.


DANIEL ENGINEERING PTY LTD
Wollongong 2 Belmore St 2500 (02) 4229 2381

If you take it to a half decent place they wont need to balance a front shaft as you really won't need to use it at speed.
Having said that I had my hilux past 100kmh on frazer island with my extended non-balanced shaft with no vibration or anything...

mine cost about 35$ square RHS there are some threads on them on here, nice cheap alternative as long as u can weld or no someone who can...

try m&a engenearing in mitchel berco are flogs.