Outer Limits 4x4 Board

G'day

looking at making a set of coil spacers for the front and rear of a vitara. Can some one tell me the measurements please.

Cheers

if you aren't willing to take your coils out and measure them, there is always this:


and if you can't find anything in there, there's this:


(which CAN be found here also)


or if thats too hard: 106mm-110mm OD, 62mm-65mm ID, and how ever high you want to make it.


BTW, just out of curiosity, how high are you planning on making them? front and rear have different lift ratio's, so if you make front and rear the same, your vit may not be level. and is it a 2dr, hard top, soft top, 4dr? too high in the front and you will have driveshaft angle/CV issues, and the rear may have ball joint issues, once again, depending on how high you are planning. also shocks and struts might need upgrading.

what material are you planning on making it out of? and how much will it cost?

you can already buy 15mm or 30mm coil spacers already. i can get some for you if you're interested. hope this helps.

Overkill make spacers in plastic and metal, both are very cheap - cheaper than you could make them yourself if you include time!

Cheers

it was late at night and I was curious. I know I am lazy!!!!!!!!!!!!!!!!

Buying looks like the go.

Thanks again