My question is will a lt230 from a zf auto swap straight on
to a R380 man. with out any mods???????
My td5 is used 90% highway & I want the higher ratio
high range.
Thanks Jeff
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
LT230 swap
Moderator: Micka
LT230 swap
rover money pit on mogs !!!
It will bolt up to the R380 OK.
If it came from a Disco II it may not have the centre diff lock.
And may not have a speedo drive - but you could swap the housing and speedo drive from your old LT230.
If your handbrake mounts to the side of the LT230, you may have to drill and tap 3 new holes - the later ones have the bosses but are not drilled.
While it is out, you should check the input gear for wear in the splines and if it is the type with the cross drilled lube hole.
I would also replace the seals and check the bearings.
If it came from a Disco II it may not have the centre diff lock.
And may not have a speedo drive - but you could swap the housing and speedo drive from your old LT230.
If your handbrake mounts to the side of the LT230, you may have to drill and tap 3 new holes - the later ones have the bosses but are not drilled.
While it is out, you should check the input gear for wear in the splines and if it is the type with the cross drilled lube hole.
I would also replace the seals and check the bearings.
John
Who is online
Users browsing this forum: No registered users and 0 guests