Outer Limits 4x4 Board

hey guys done a body lift wondering how to lift standard bar 50mm?

thanks in advance

unbolt it all and bolt into the higher set of bolt holes, once you start you will see its very easy. the loop in the middle of the ally is no longer usuable at all tho as it is held by only two bolts.

Fit it the bottom bolts of the bar to the top holes of the chassis and only fit 2 bolts. If that makes sense.

yeah ok, but what about the two side bits with the lights in em?

bolt them back into the ally centre section then tack the brackets into place, is the quickest fix.

also u can swap the side bracket left to right and flip them upside down and they will bolt back up in place

skippy's GQ wrote:also u can swap the side bracket left to right and flip them upside down and they will bolt back up in place

Hmmm, good one, didn't know you could do that!

beretta wrote:

skippy's GQ wrote:also u can swap the side bracket left to right and flip them upside down and they will bolt back up in place

Hmmm, good one, didn't know you could do that!

did this myself this arvo... while they do sort of flip, they needed a couple of big whollops with the pusuader for the inner barckets to align with the bumper end bolt holes. Not the best fit inside, but ya wouldn't know once put back together.