Outer Limits 4x4 Board

okay i got 30" muddies on my sierra (no other mods)
they are on the stock rims...
the rubber is rubbing (no pun intended) on the bumper and also on a bit im assuming is the chassis... only when i turn...

can i angle grind these with no problems you reckon?

On the back of the bumper there is some tube that mounts onto the end of the bumper from the chassis, cut it off near the chassis. The tyres when turned are most likely also hitting your springs, you'll need to limit your steering or offset your rims to fix that (or you could grind part of the springs off till they clear )

There will most likely be some more rubbing on other places but nothing a BFH can't fix

Mark.

bfh?

where can i get spacers from?

chunkz wrote:bfh?

where can i get spacers from?

big ShortyIQ hammer

i take u mean wheel spaces try snake racing

bfh has already been used
and so was the angle grind on the bumper

wheel spacers im guessing means they come out more...
which means i probably need bigger flares?

i didnt read this in the fine print

chunkz wrote:bfh has already been used
and so was the angle grind on the bumper

wheel spacers im guessing means they come out more...
which means i probably need bigger flares?

i didnt read this in the fine print

try some rims with bigger offset instead of wheel spaces will be cheaper
theres a few sets on outers for sale i think

also wheel spacers are illegal on road

As are the 30's

whya re the 30's illegal?

Because they're 15mm bigger in diametre. Also 30"x9.5 need to be on 6.5" wide rims, not 5.5".
I have them, but I also have a set of standard tyres/rims if I get defected.