Page 1 of 1
blinkers issue....
Posted: Wed Jan 04, 2006 3:56 pm
by Mousie
hey when i try indercate it keeps blowing the fuze but the hazzards work fine...
no idear what it could be and no idear were to start looking
any idears would be nice
cheers
Posted: Wed Jan 04, 2006 4:48 pm
by G_loomis
if you have a manual go looking for the electrical diagram and try and work out what the indicator system uses that the hazard light system doesnt. then that may give you a heads up as to where to look.
But straight off if there is a fuse blowing, that noramlly means a bad earth, bare wire (or dodgy connection) or something similar.
Posted: Wed Jan 04, 2006 4:48 pm
by Mousie
fixed
found a towing loom that had been choped in half and was shorting out on that to the body
it was curled up in the gard
Posted: Wed Jan 04, 2006 4:50 pm
by G_loomis
we must of been typing our messages at the same time...so it came down to a bare wire hey
Posted: Wed Jan 04, 2006 5:25 pm
by Mousie
yep lol
heatshrinked them all up no more shorts for them...