Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Question on Mods in NSW after engineers cert.
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Question on Mods in NSW after engineers cert.
In NSW there is no restiction on the engine size for 4WDs. If you already have a engineers cert and then go up in engine size, do you have to get the whole vechicle re-engineered or just the new engine? (no plans but as an example from 6.5lt to 7.2lt)
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Just the engine.
My hilux was engineered before I dropped the 1uz in it. When I had the motor swap engineered he didn`t care about the other stuff that was allready done. But he did need a copy of the original report. If you can`t produce a copy of the original report then you would have to have everything else re-engineered.
My hilux was engineered before I dropped the 1uz in it. When I had the motor swap engineered he didn`t care about the other stuff that was allready done. But he did need a copy of the original report. If you can`t produce a copy of the original report then you would have to have everything else re-engineered.
Who is online
Users browsing this forum: No registered users and 1 guest