Outer Limits 4x4 Board

My air con gave up on me upon inspection the tentioning pully has disinigrated. I checked out a mates car (lwb) and his tentioner is in a different location, the gregorys book has a picture and mine is different has any one seen this before?

petrol / diesel - engine size?

I have noticed that they vary. As I had been looking for ways to lift my PTO winch higher without the shaft hitting the belt.

I think there is generall three tyes of fitments - Factory install, Dealer fitment and Aftermarket.
Mine was different to the Gregorys manul also.

As for the Idle pullys. I went thru a couple of those when I used o play in the mud alot also. Just found that it was one of those things that needed a spray of WD40 or similar every now and then.

So matto did you end up getting another tensioner to put on? I had another look at mine and i can't see why you wouldn't be able to put the same type that I have on there. Might be a different size belt but thats about all.