Page 1 of 1
4AGZE swap driveshaft ???
Posted: Mon Jan 23, 2006 7:48 am
by zuku26
Hello, I don't know if this question has been covered... I tried searching first but it keeps saying no matches found.
I would like to know what you guys with 4AGE/4AGZE swaps did about the driveshaft. Will the factory samurai driveshaft work. Just to help a bit I'm dealing with a factory 2wd samurai/sierra. So no front axle and transfer case to deal with.
Posted: Mon Jan 23, 2006 12:52 pm
by Guy
We never got 2wd Zuks in aus ... so I doubt that anyone here will be of alot of practical help .. plenty of theory.
Posted: Mon Jan 23, 2006 2:26 pm
by zuku26
The drivetrain on a 2wd and 4wd are the same minus the fwd tranfer case. I just need to know if the how they did theirs. Did the drive shaft from the sierra plug right into the toyota piece, did they have to make a custom drive shaft, Basically the run down on how they got the rear wheels to move. Also what tranny they used. I plan to use a T-50, originally I planned a k-50 and a 4age, but I figure if I'm going to go through the work I might as well do it right,
Posted: Mon Jan 23, 2006 3:05 pm
by bazooked
from memory ya need a toyota sprinter rwd box, and u will definately have to beef ur tail shaft, and no the sierra yoke wont fit in the toyo box.
Posted: Sat Jan 28, 2006 8:40 pm
by Drew
get the t50 shaft put the sierra diff flange on measure & have the shaft shortened or lengthened to suit