Page 1 of 1
edging for flares?
Posted: Fri Jan 27, 2006 1:22 pm
by missinbits
seems cheap etc but i gotta get them back under something
how affective is this edging stuff
how many mm will i need to get the 31's under my 89 pajero
is this even legal etc it has no sharp edging etc but i heard its not quite legal etc
anyways would 100mm fix my problem?
and how legal is this stuff?
cheers
Posted: Fri Jan 27, 2006 7:37 pm
by Noisey
Posted: Fri Jan 27, 2006 7:39 pm
by missinbits
Posted: Sat Jan 28, 2006 8:37 am
by 88pajero
Im not sure about the garden edging but I used some flexi flare from don kyatt 4x4. It already has a lip so all you have to do is drill some small holes and self tap it to the inside lip of you guards, cost me a whole of about $60...
Posted: Sat Jan 28, 2006 9:17 am
by -Scott-
88pajero wrote:...drill some small holes and self tap...
Tek Screw!
Posted: Sat Jan 28, 2006 4:24 pm
by missinbits
NJ SWB wrote:88pajero wrote:...drill some small holes and self tap...
Tek Screw!
im using potrivets on mine and the stuff im using is nearly the same as the stuff your using it also has lips on the edges etc.
im putting them on tom'w right after i pull the starter motor out
thats 2 in a month now
Posted: Sat Jan 28, 2006 9:12 pm
by 88pajero
Haha, good old starters, im taking mine out tomorrow as well. Its not dead yet but its starting to play up, hopefully I can clean it up good enough...
Posted: Sun Jan 29, 2006 8:31 am
by Overkill
missinbits wrote:im using potrivets on mine
Personally I would just use screws (self tapers) because when you need to get them off to clean all that lovely mud from behind, rivits can become a real pain in the a**!
Each to their own.
