Page 1 of 1

Ok. You Got me. How do I get the Oxy Sensor out???

Posted: Fri Jan 27, 2006 2:06 pm
by drewe
Got my new Oxy Sensor. But there is a problem.

How do you get the old one out???

There is this big mutha nut on it - I need a ring spanner? The largest I have is a 19, and it doesn't appear to be big enough... Do I just need to buy one or is there another trick?

I also am replacing my distributor - pulled it apart, Vaccum advance was @#$@#, the plate was hard to turn, the weighted governor on the bottom jamming and bits of broken plastic inside... Think I have found the root of most of my issues!

Drewe

Posted: Fri Jan 27, 2006 6:10 pm
by drewe
ok, I was out so I purchased a 22 ring spanner. Still won't come out! I even left degreaser on the bolt for an hour or two before trying..

:(

GRRRRRRR.

:crying:

Posted: Fri Jan 27, 2006 7:01 pm
by runnin4life
hmm tried an oxy on it if all else fails cut the fuker out
lol
cheers
elliot

Posted: Fri Jan 27, 2006 9:09 pm
by murcod
They literally weld themselves in. I got my old one out and half the thread was left in the hole. :bad-words: