Page 1 of 1
Need help with a comp wiring loom for Range Rover
Posted: Sat Jan 28, 2006 8:29 pm
by schuler
I am building a competition Range Rover and need someone to do a rewire, i want to mount all relays inside, strip out all non essential stuff, the vehicle is in the Dandenong Ranges Melbourne, any help would be greatly appreciated. The vehicle currently has no interior, and the roll cage will go in soon, i assume that after the cage is installed will be the best time to rewire, any comments or quotes would be greatly appreciated, time is not a major issue, quality of work is.
Thanks in advance
Steve
Posted: Sat Feb 04, 2006 9:05 pm
by SWAT
If you were only in tas
Posted: Sun Feb 05, 2006 2:02 pm
by greenfourby
Have you considered
http://www.painlesswiring.com they make lots of different generic harneses for race cars etc.
Would be a good way to start then just connect and go
my 2c
If you are interested I can source them for you
Posted: Sun Feb 05, 2006 5:16 pm
by Spike_Sierra
just a quesiton for ya bruce(swat), what would be the rough price on a rewire, eg engine swap to efi?
RR Rewire
Posted: Mon Feb 06, 2006 3:57 pm
by schuler
Thanks greenfourby, i have just returned from the states and i was considering bringing back one of the many hot rod looms available there.
I still think i will end up with a far better job if i get a custom loom, i have got one chance to do it right, so i'll keep looking.
Thanks for the feedback though.
Cheers
Steve