Outer Limits 4x4 Board

do the sierra gearbox's (4 and 5 speed) have the same output shafts? and hence use the same jackshaft (obviously with different flanges)? or are they different?

antt wrote:do the sierra gearbox's (4 and 5 speed) have the same output shafts? and hence use the same jackshaft (obviously with different flanges)? or are they different?

I had to change end of jack shaft after fitting 1.3 into my 1.0, so
splines are different sizes.
but the two jackshafts can use half of each as a conversion.
mine is a 1.3 jackshaft, with half a 1.0 yoke at the t case end.
1.3 jackshaft is 12mm ish shorter, too.

christover

maruti's may be another story, and spline on output could be same.

Hah, Was just about to ask you that. Thanks Cristover1.