Page 1 of 1
Interesting lift method..
Posted: Fri Feb 03, 2006 6:03 pm
by murcod
Taken from the Daihatsu Driver's forum (in reference to a Sportrak/ Feroza lift options) :
ive just done a spring over axle conversion on mine it gave me 6"lift on rear had to have a prop spacer made though .and managed to get 4"on front by cuttin lower bump stops and torsion bars off then replaceing front shockers with mondeo v6 suspension legs .then i did a 3"body lift on front down to a 1"at the rear to leval it all out and 33/12.50/15 fit without rubbing and it drives 10 times better than it did
Posted: Fri Feb 03, 2006 7:22 pm
by The Rocky
Sounds like too much hard work
Posted: Fri Feb 03, 2006 7:38 pm
by murcod
I just happen to have some V6 Mondeo shocks sitting in my garage- any takers?
Posted: Sat Feb 04, 2006 9:03 am
by HotFourOk
It'd be so lovely to get rid of the torsion bar setup
Posted: Sat Feb 04, 2006 9:21 am
by r0ck_m0nkey
I want to see pics of this beast with it's levelled out body lift.
Posted: Sat Feb 04, 2006 1:00 pm
by Rb25sil80
So what is it apparently using as front springs since the torsion bars have been cut out?
Cheers
Posted: Sat Feb 04, 2006 1:09 pm
by murcod
I don't know- the description of using Mondeo parts is a bit vague and there are no pics in the thread.
BTW the Mondeo shocks are nothing special, just your normal MacPherson strut type set up with a lower wishbone connected to a front sub frame.
Posted: Sat Feb 04, 2006 2:45 pm
by SimplyPV
sounds like a booty fab...
