Page 1 of 1
wheel size
Posted: Fri Feb 03, 2006 6:13 pm
by macy918
Hi guys,
i was wondering whether it is possible to run different size rims on a series 1 disco (late 93 built). it seems that there is a much bigger choice of 2nd hand tyres to fit a 15" rim out there than 16's. i'm guessing if u can that it follows that you can run 32" tyres without too many dramas???
andy
Posted: Fri Feb 03, 2006 6:25 pm
by RaginRover
I wouldn't bother - the 16" tyres have a much higher load rating and are a lot more structural IMO.
What size are you looking for ?
Tom
Posted: Fri Feb 03, 2006 6:30 pm
by macy918
i would like to run 32's but have been told before that there is an issue with torque and gearing if you go bigger than 245/75R16 which i believe is 31"?? so i will probably go those.
Posted: Fri Feb 03, 2006 10:25 pm
by walker
32's will run ok on a D1....but they wont fit without cutting the guards. The D1 had a lot narrower wheel arches than the D2 so unless you want to start cutting metal, 31's are the biggest you will fit.
Posted: Fri Feb 03, 2006 10:41 pm
by ISUZUROVER
walker wrote:32's will run ok on a D1....but they wont fit without cutting the guards. The D1 had a lot narrower wheel arches than the D2 so unless you want to start cutting metal, 31's are the biggest you will fit.
I have seen a S1 disco on with 235/85-16s (32") on the stock steel rims and no guard trimming. Didn't have a very close look at it, but I think it only had a spring lift and no BL - but not sure.
Posted: Sat Feb 04, 2006 9:39 am
by macy918
thanks guys