Outer Limits 4x4 Board

can any one tell me the valve clearences on a tb42



cheers bill

asked this not long ago and just checked them today.i was told .38mm

just did mine an hour ago at .38 car now sounds like an old diesel, i think the .38mm might be for a fresh motor, i try again @ 14 th. After i did the head on my car I lost 100km to a tank of 80ltr gas, mech said it must be the clearances.

hrrmmmmm .38 for both? i'm used to one setting for inlet and a slightly bigger one for exhaust.... mine sounds like an old diesel loco and needs doing soon.

whats good for LPG mine are set to 0.38mm as per specs but economy seems worse since i replaced the cylinder head................... 400km for 85Lt LPG on the highway, mine is AUTO and runs 33"s am I wasting my time getting it dynoed for better economy?

thanks brunsy