Outer Limits 4x4 Board

Posted: **Mon Feb 13, 2006 6:42 pm**

There was a link to an article about ARB compressor mainanance and rebuilding a while ago, can anyone direct me to it?

snckma!

Peter.

Posted: **Mon Feb 13, 2006 7:12 pm**

what do you wanna know specifically ?? i've repaired and rebuilt a few of them before

Posted: **Mon Feb 13, 2006 7:19 pm**

Basicly, are there any spares I should get before I pull it down.
Peter.

Posted: **Mon Feb 13, 2006 8:22 pm**

If there is a write up, or if someone could do one that'd be sweet....as I think the one in the zook is on its last legs...its sounds horrible when its running....

Posted: **Mon Feb 13, 2006 8:34 pm**

the inlet and exhaust valves are made of plastic and after a while fatigue to the point of desintigration. doesnt cost much for spares just hard to find them in stock.

ps: if it sounds like a bucket of bolts when its running (not unlike a nissan)then its on its last legs.

Posted: **Mon Feb 13, 2006 8:41 pm**

http://www.arb.com.au/alac/alsp/3-01.pdf

exploded diagrams for the arb compressers

Posted: **Thu Feb 16, 2006 3:40 pm**

my arb compressor sounds like its about to throw a rod out the side , i dont htink its even worth rebuidling

How hard is it to rebuild

?????????

Posted: **Thu Feb 16, 2006 5:12 pm**

you should always deflate the air tank when finished with the comp

also you can tank the air tank off and give it a quick wipe out incase of any condensation

Posted: **Thu Feb 16, 2006 5:27 pm**

spazbot wrote:http://www.arb.com.au/alac/alsp/3-01.pdf

exploded diagrams for the arb compressers

Ace!!
thanks for that.
peter.

Outer Limits 4x4 Board

maintaning arb compressor

maintaning arb compressor